Call Us +852 5109 2067 · info@octominer.com

SETUP

WATCH THE VIDEO BELOW FOR INSTRUCTIONS ON HOW TO ASSEMBLE AND SET UP THE OCTOMINER B8PLUS MOTHERBOARD.

IF THE MOTHERBOARD DOES NOT BOOT, THEN PLEASE TRY THE FOLLOWING:

  • RE SEAT THE RAM
  • REMOVE ALL GPU’S AND TRY BOOTING WITHOUT ANY GPU ADDED
  • REMOVE OR RESEAT SSD
  • CLEAR CMOS
  • MAKE SURE THE PSU IS POWERED ON (ATX PSU NEEDS JUMPER PIN).
  • REMOVE AND RECONNECT THE 6PIN MOTHERBOARD POWER CONNECTORS TO DIFFERENT CONNECTORS ON THE MOTHERBOARD
  • WITH SOME CARDS, THE FOLLOWING BIOS CHANGES MIGHT BE NEEDED: Bios > Advanced tab > CSM configuration > set CSM to disabled > Back to top level of bios > Chipset tab > North Bridge Configuration > Graphics Configuration > Aperature Size > Set to 2048 > Save and reboot